Drift Stabilisation Preferences

Drift Stabilisation Failure Mode

This preference will allow the user to set how Fusion will handle a failure with Drift Stabilisation; the options are listed below. The default is “Abort Protocol”.

Drift Stabilisation Settle Delay

The specified delay will be used to allow extra time for completion of device movement. The default is 0s.

Apply MultiField Refocus

When ON, drift stabilisation will refocus at each field using the last known hold position recorded for that field. This option has no effect on non multi-field protocol types.

Enable Drift When Recording Field

When ON, drift stabilisation will enable when recording a field position in the multi-field table to ensure a valid offset is stored.